Editable Construction Method Statements & Project Documentation Portal. He is a Idaho Registered Contractor and a previously Licensed Irrigator in the State of Texas. The garbage bin shall be provided at the working area and Supervisor shall ensure its must be collected regularly and disposed off at the approved dumpsite. Every precaution is to be taken to avoid segregation of mixed materials and to ensure that they do not become contaminated with foreign matter. At the end of this article you shall find links to download method statements samples for road works. The mixed material as delivered to the laying site shall be between 140 degrees Celsius to 160 degrees Celsius. Filler: Filler shall be either Portland Cement complying with B.S. Thanks to all authors for creating a page that has been read 338,701 times. After all the above works is completed, the supervisor is to ensure that the site is to be tidied up and all excess materials are to be discarded away from the site. Also ensure the mark on site is visible and suitably protected during work construction. After cleaning the surface, a prime bitumen coat has to be applied in accordance with engineering specifications. Rolling shall always commence from the lower to the higher side of the carriageway. Earth Formation:  Where soft spots and unsuitable materials found, it shall be removed and back filled with approved suitable material and compacted in accordance to the agreed rolling pattern.

The asphaltic concrete binder course shall be laid by a paver in single layer. If your underlying soil is sandy, you will need 4 inches (10.16 cm) of crushed rock.

Allow MC-1 to completely adhere to the surface until it's dry to the touch. The size of the aggregate used to create asphalt pavement ranges from 1/2 inch to 3/4 inch (1.27 cm to 1.9 cm). Compaction of the sub base layer shall be carried out by using vibrating roller to achieve relative dry density as per specification.

If they did it properly and if it's truly recent, they can come back and heat the area up to make it blend properly.

0 necessary to complete the construction of hot mix asphalt concrete pavement consisting of one or more courses on a previously prepared base, seal coat of asphalt cement and cover aggregate, and bituminous surface treatment in single or multiple courses. The asphaltic concrete wearing shall be plant mixed with bitumen content. An optimal slope is 1/4 inch per foot (0.635 cm per 30.48 cm). % of people told us that this article helped them. Should we have them redone again? All workers shall be provided with PPE (Personal Protective Equipment) and shall be worn at all time on site. References inquiries about design procedures and cost estimates at any time.